Products/ Bridge Boards / USB 3.1 Gen 2 / to SATA

U3-SATA314

USB 3.1 (10Gb/s) to SATA III (6Gb/s) Bridge Board

Highlights
  • USB 3.1 to SATA III (6Gb/s) Bridge
  • Support USB Attached SCSI Protocol Specification Revision 1.0
  • Supports both HDD, ODD and SSD
  • Provides Jumper for Read-only (Write Protect) or Read/Write selection
  • Direct Connect to SATA Drive
  • DC Power Input: Big IDE 4-pin DC Power Connector
Introduction

U3-SATA314 is an USB 3.1 to SATA III bridge board. It has an USB 3.1 SuperSpeedPlus device port and a SATA 1.5Gbps/3Gbps/6Gbps host port. The high performance USB interface can connect to any super speed plus/ super speed/ high speed or full speed USB host or USB hub and can instantly be detected as a USB mass storage device.

U3-SATA314 provides a Jumper which allow user to set the function for selecting SATA Read-only (Write Protect) or Read/Write.

Technical Specifications

USB to SATA Bridge Board : ASMedia ASM1351 (TID# 5040000002)

  • Compliant with USB3.1 Specification Revision 1.0
  • Compliant with USB Specification Revision 2.0
  • Support USB Super-speed Plus, USB Super-Speed, High-Speed and Full-Speed Operation
  • Supports USB Mass Storage Class, Bulk-Only Transport Specification Revision 1.3
  • Support USB Attached SCSI Protocol Specification Revision 1.0
  • Complies with Serial ATA Specification Revision 3.2
  • Serial ATA bus up to 6Gbps Signal bandwidth
  • Support Spread Spectrum Control of USB3.0 and SATA interface to improve the EMI performance
  • Support SATA Hot-Plug
  • Support ATA/ATAPI Packet Command Set
  • Support ATA/ATAPI LBA48 addressing mode
  • Integrated 8-bit micro-processor with embedded program RAM and ROM
  • Support SPI NVRAM for Vender Specific Application of USB Device Controller
  • Support Write Protect for HDD
    • Read-only (Write Protect) or Read/Write Setting Header
  • LEDs:
    • Power indicator LED Header
    • SATA activity indicator LED Header
  • Self Powered Mode Operation
  • DC Power Input:
    • Big IDE 4-pin DC Power Connector
Physical Dimensions
  • 6.40cm x 3.65cm x 2.83cm
  • Direct Connect Vertical type
  • NW:17.6g
Hardware Requirements
  • Desktop PC: with either a built-in USB (1.0 or 2.0 or 3.0 ) controller or an USB (1.0 or 2.0 or 3.0 ) to PCI Host Adapter equipped with an external USB port.
  • Laptop PC: with either a built-in USB (1.0 or 2.0 or 3.0 ) controller or an USB (1.0 or 2.0 or 3.0 ) to CardBus PC Card equipped with an external USB port.
Kit includes
  • U3-SATA314 Bridge Board
NO FILE AVAILABLE FOR DOWNLOAD!